JETCO TS-1000 Torque Meter
Tech Tip:

Sending data from the TS-1000 to a computer

 

The TS-1000 has a standard RS232c communication port.   Use this port to send data to a computer to log torque data and to create torque files for traceability.

 

You can also use this port to send directly to a serial dot matrix printer.

 

The data is sent in ASCII format with the following protocol:

Bits per second: 4800

Data bits: 8

Parity: None

Flow Control: None

 

You can send the data out the TS-1000 communication port in two ways:

 

1.      Press the save key and the individual data on the display will be sent (you must be in peak or first peak mode).

2.      Enter the menu mode, scroll to “send mem” press save and send ALL the data in memory.

 

The data is sent as follows:

DDD  TTTT  UUUU  0000

 

Where:

 DDDD is the data number

 TTTT   is the torque value

 UUUU  is the torque units

 0000      Not used

Example:

 

043  -317.7   lbf.ft.  0000  (the zero’s are not used)

 

This is data number 43, the value is –317.7 and the units are lbf.ft..

 

HOW TO SET UP THE COMPUTER AND THE METER:

1.      Determine which com port is available on your computer (usually comm. 1)

2.      Plug the computer to meter adapter in the com port that is available

3.      Plug the telephone type cord into the computer adapter and the meter com port

4.      Under the Windows desktop select the following:

Start-Programs-Accessories-Communications-Hyperterminal

Select the Hypertrm icon

Name the new connection “torque” or “TS-1000”. Press OK

Select the  com port that you are using under “Connect using” box. Press OK

Port Settings:

            Bits per second:             4800

             Data Bits:                         8

            PARITY:                         NONE

            Stop Bits:                         1

            Flow Control:                         None

Press OK

You will now be connected.  Press the Send key to verify that data is coming in.  If the data is not recognizable, do the following:

 

Select File-Properties

            Select Settings from the properties window

            Emulation: ANSI

            Select ASCII Setup.

                        Check the Append line feeds to incoming line ends.

                        Press OK.

                        Press OK

Disconnect the connection by selecting Call-Disconnect

Reconnect the connection by selecting Call-Call

Press the Save key to verify the data is being sent.

 

See the Windows operation manual on how to create files within the Hyperterminal window.

 

Sending to a printer:

Refer to the printer operation manual for instructions on how to set the printer to ASCII-4800BPS-8-1-n.

 

 

 

 

 

 

 

 

JETCO 1808 E. Evergreen St. Duarte, CA 91010  www.itorque.com